Redhat,that`s not a bad price at all for the set up you purchased.For that price it`s easy to buy some extra accesories and still get a good deal.I may have to consider that if it is still the same price in a week or so.The car ate up my extra money with a new radaitor.Damn Murphy.I ordered one of these last week and I'm impressed with the quality. All you need are dies, powder, bullets and primers to get going.
Link Removed
You can get extra turret plates for $9.19
Link Removed
I noticed one drawback when playing with my press today. Link Removed With the 4 hole plate the holes are very close together and my standard die lock rings won't work with their plate. I tried RCBS, Pacific and C&H and none would work. Lyman uses a hex nut on their's and it works fine, plus they are the cheapest of all the die nuts. I guess I have to buy extra rings made by Lee or Lyman to get them to work. Either that or I'm going to turn them down on my lathe. Just a little heads-up.Redhat,that`s not a bad price at all for the set up you purchased.For that price it`s easy to buy some extra accesories and still get a good deal.I may have to consider that if it is still the same price in a week or so.The car ate up my extra money with a new radaitor.Damn Murphy.
You might try some of Link Removed.I noticed one drawback when playing with my press today. Link Removed With the 4 hole plate the holes are very close together and my standard die lock rings won't work with their plate. I tried RCBS, Pacific, C&H and Lyman and none would work. I guess I have to buy extra rings made by Lee to get them to work. Either that or I'm going to turn them down on my lathe. Just a little heads-up.
Thanks, but I have some like that. RCBS uses them and the problem is they are too big in diameter. I know Link Removed will work , I tried them.You might try some of Link Removed.
I appreciate the heads up and all the info from everyone.It will definately help toward my decisions when purchasing my reloading equipment.I noticed one drawback when playing with my press today. Link Removed With the 4 hole plate the holes are very close together and my standard die lock rings won't work with their plate. I tried RCBS, Pacific and C&H and none would work. Lyman uses a hex nut on their's and it works fine, plus they are the cheapest of all the die nuts. I guess I have to buy extra rings made by Lee or Lyman to get them to work. Either that or I'm going to turn them down on my lathe. Just a little heads-up.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?