stewie-Y
New member
Hey guys.
I picked up a Mosin Nagant and it's almost ready to go, but as I reassemble the bolt and measure the firing pin it is always protruding.
I've watched various videos and tried seeing what I'm doing wrong, but I can't figure it out. I've unscrewed it far enough so that the little gauge on the back goes as far back as possible, but it still hits the 95mm measure on my tool. I also tried screwing it in as far inward as possible, but that obviously just made it it protrude even more.
Here are some pictures of the bolt while I was measuring it. At that time the gauge on the back was sitting flush with the back of the safety.
Link RemovedLink Removed
Link RemovedLink Removed
Any help is greatly appreciated!
I picked up a Mosin Nagant and it's almost ready to go, but as I reassemble the bolt and measure the firing pin it is always protruding.
I've watched various videos and tried seeing what I'm doing wrong, but I can't figure it out. I've unscrewed it far enough so that the little gauge on the back goes as far back as possible, but it still hits the 95mm measure on my tool. I also tried screwing it in as far inward as possible, but that obviously just made it it protrude even more.
Here are some pictures of the bolt while I was measuring it. At that time the gauge on the back was sitting flush with the back of the safety.
Link RemovedLink Removed
Link RemovedLink Removed
Any help is greatly appreciated!