Bulged Brass

[super40]

I am familiar with brass bulging in factory handguns that have unsupported chambers, and I have had issues in the past from range brass that I reload sticking in the chamber.

Does anyone have any experience with reloading equipment from any of the following manufactures:


Lee Bulge Buster?

Redding G-RX push thru die?

Magma Case Master?

Case Pro 100?

AUTO DEBULGE 40?


Please tell me about your experience with any or all of the products you have used and how well they work for you?

 

[noylj]

All I have used is the Lee Bulge Buster and it works perfectly.
Others are more expensive, but I can't see how they can be "better."

 

[melloyello]

Lee Bulge Buster for me too

I am familiar with brass bulging in factory handguns that have unsupported chambers, and I have had issues in the past from range brass that I reload sticking in the chamber.

Please tell me about your experience with any or all of the products you have used and how well they work for you?

I used the Lee "Bulge Buster" for 40S&W and 380 acp, loaded cartridges with the simple Lee Reloading Single stage press.
It is basically a factory crimp die, ram rod, guide tube and a catch case.

If you have the ram rod you can remove all the internals in Lee Factory Crimp Die and push the cases (or cartridges) through the FCD.

It is a similar kit to the Lee bullet sizing kits.