VIDEO: How to Install a Full Length Magazine Tube on a Shotgun

[Amsdorf]

I purchased a full length magazine tube from CarrierComp, a titanium tube, for my M4 Benelli and installed it yesterday. With the right tools, and with enough patience, doing it was quite straightforward. But you have to get over the fear that you are going to ruin your receiver when you start blasting away with the heat gun. In fact, unless/until smoke starts to come out, you have not heated it up enough.

Hope some may find this video useful if they decide to install a full length magazine tube for themselves.

I can't say enough good things about the quality of CarrierComp products, the fit and finish are truly superb. Great folks, Kip and Marcy, own/operate the business.

 

[maine04619]

A torch or pu tit in the over on 400 for 45 min does the job to. Same way to jailbreak many suppressors.

 

[Amsdorf]

You should follow the instructions provided by the maker of the magazine tube. No open flame and putting it in the oven is a stupid idea.