m1600 makeover

[signs1919]

this is an armscor 22 lr. i found it really cheap. it shoots great so i decided to give it a makover. added a 25 shot clip, carry handle scope monut, scope, bipod, laser/flashlite and front handle. when i was all done i airbrushed it then gave it three coats of satin clear. what do you think? ps hope i posted this in the right fourm.

 

[Felix]

Good job!

 

[signs1919]

m1600

thank you

 

[vanillasavage]

Where did you pick up the 25 round mag, scope, grip, and bipod?

 

[signs1919]

i bought the mag at Link Removed and the rest of the stuff on ebay. the mag is from a armscor ak22 and you must remove one inch off the top of the plastic clip holder for it to fit. easy to do

 

[hp-hobo]

That's a nice piece, slickly set up! I have an Armscor M1600R... The same rifle as yours except with a retractable stock.

Do the 25-round mags fit well (not loose and sloppy) after being cut down, and do they feed as well as the 15-rounders?

Thanks.

 

[signs1919]

the mags fit good and i've had no jams with rapid firing. i would like to get my hands on a folding stock

 

[lyttonj]

Scope mount

How did you get the scope mounted? I can not find any mount solutions that will fit on the handle.

 

[gunnerbob]

Did you use gloss clear coat?

 

[hp-hobo]

How did you get the scope mounted? I can not find any mount solutions that will fit on the handle.

A standard M-16/AR-15 carry handle rail adaptor will work fine...

 

[signs1919]

carry handle

i used a regular carry handle mount but had to machine the handle out for the mount to fit. if you don't have access to a machine shop just sand the mount or handle by hand. it's real easy. on the paint end i used satin clear. thanks