Crossbreed Holster (Bersa 380cc)

[Evil_GT]

Hi guys. I carry a Bersa 380cc model, and have a crossbreed supertuck holster for it.

I wear it in the 4 o'clock position, and the way I have it adjusted prints just a tad. I am 6'1 and 215lbs. It isn't to bad, but if I bend over the butt end of the gun prints just a tad, also depending on how I am standing prints just a tad.

If anyone is using a gun very similar to this in a Crossbreed holster, or you have a BersaCC model, what adjustments did you make to the crossbreed for best concealment.

Thanks

 

[Phillip Gain]

I don't have this specific gun or holster...but I know what you're talking about.

My suggestion...move it to the 4:30 or 5:00 position (so the gun is more flat against your back).

Another possibility, if the belt clips are adjustable - front clip up higher on the leather, and rear clip lower on the leather, to give the gun a more forward cant, pulling the butt up against your waist better. Just be careful that your draw isn't obstructed by your waistband.

 

[snatale42]

Make sure the clips aren't even, The front should be higher than the rear which will give you more forward cant.

 

[Evil_GT]

Thank you for the help guys, I'll try it out later and let you know how it works!